The maintenance of three-axis drilling and tapping center mainly includes the following aspects:
Regular cleaning: The drilling and tapping center will accumulate a lot of dust and cutting fluid residue during long-term operation, which will affect the heat dissipation and precision of the equipment. Therefore, the equipment should be cleaned regularly, including the body, guide rails, workbench and other parts. When cleaning, special cleaning agents and soft cloth should be used to avoid using highly corrosive cleaning agents or sharp objects to scratch the surface of the equipment.
Lubrication and maintenance: Lubrication is an important part of the maintenance of the drilling and tapping center. The lubricating oil and grease inside the equipment should be checked and replaced regularly to ensure that all parts can operate smoothly. At the same time, the pipelines and joints of the lubrication system should also be checked to see if they are intact to avoid oil leakage.
Fastening inspection: When the drilling and tapping center is in operation, the various components will be affected by vibration and impact, and are prone to loosening. Therefore, the fasteners of the equipment should be checked and tightened regularly, including screws, nuts, pins and other parts. During the inspection, special tools should be used to ensure that the fasteners reach the specified tightening torque.
Electrical system inspection: The electrical system is the core part of the drilling and tapping center, and its stability and safety are directly related to the operation of the equipment. The electrical system should be inspected regularly, including power cords, motors, controllers and other parts. During the inspection, attention should be paid to checking whether the wiring of the electrical components is firm, whether the motor is running normally, whether the controller displays normally, etc.
Daily inspection: In addition to the maintenance and care of the above aspects, a daily inspection system should also be established. Before starting the machine every day, a comprehensive inspection of the equipment should be carried out, including lubrication conditions, fastener status, electrical system conditions, etc. Problems should be dealt with in a timely manner to ensure that the equipment can operate normally.
Air source cleanliness: Ensure that the air source is clean to avoid excessive water vapor in the air pipe causing rust on control valve components.
Accessory maintenance: Keep the pipeline unobstructed, regularly check whether the air pipe and water pipe have leakage or folding, and ensure that the pressure plate bolts of each fixture are tightened.
Timely chip removal: Clean up the accumulated chips regularly to prevent external switch failure. Pay attention to abnormalities: Observe the machine carefully before handing over or leaving get off work to see if there are any abnormalities, such as the sound of the spindle rotating, tool changing action, etc. If any abnormality is found, stop the machine immediately for inspection and treatment.
